IKEA Office Drawer Makeover {Mod Podge}

I’m loving this IKEA Office Drawer Makeover!

It’s time to get craftin’ around here a bit more.  I have been spending the last few weeks really cleaning out my craft room and getting it organized.  It’s getting to be pretty awesome.  Now all that remains is plowing through some projects so that I can clear off the bed, since the room is also technically a guest room.

I’ve had this little drawer organizer for over 10 years.  It’s one of the first things I ever bought from IKEA, and it’s one of the only things I’ve bought from there that did not require assembly.  I LOVE assembling IKEA furniture.  I’m weird like that.

I decided that since we are going to be in this house until our kids are grown and in college, it’s time to commit to spiffing this thing up.  I also organized all of my office stuff, and purged a lot, so it’s much more feasible to use this in a logical way.  The little orange tabs you see above are what I used to temporarily label the drawers while I pondered what to do with this thing.

You may or may not have seen my sewing & crafting organizers, but this is the same fabric.  Here’s my before and after; below you’ll see a bit about my process.  Doesn’t it look soooo much cooler?!

To prepare the fabric, I measured the width of the drawers. I know that fabric tends to stretch a bit when you use it with Mod Podge, but I also wanted a wrap around on the drawers, so I added about 1/2 inch to the measurement.  I pressed my fabric in the middle of the pattern- you can see the crease below.  Then I measured the height of the drawers and cut very precisely.  I actually had to do this twice because I messed up and Mod Podged a piece on upside down.  Whoops.  Note:  once you put the fabric on, it’s never going to be the same, so if you mess up, you mess up.  It’s best to have extra fabric for this project, unless you are perfect in every way.  Ha.

I knew that I’d be working on this in spurts, so I labeled the pieces of fabric with the corresponding drawer and also an arrow to remind me which was way up.  To do this, I used tailor’s chalk so it just brushed off before I Mod Podged. I didn’t want to leave anything to chance- that’s dangerous for me.

To attach the pieces, I applied a layer of MP to half of the drawer face, pressed the fabric down, and gave it a good rub down.  Then I did the other side.  Before the MP dried, I also poked a hole where the drawer pulls would go back in later.  I just used a sharp pair of scissors.  On the right, below, you can see the little bit of fabric that wrapped around the edge.  These were stubborn- I had to hold them down for about 30 seconds while the MP did it’s work.  I coated the top of the fabric with two coats of MP.

For the top, I measure the fabric and cut to size.  There’s a metal trim, and the fabric stretched over it, so after it dried completely I used an exacto knife and trimmed it off.  I coated the top with Hard Coat Mod Podge, and then sprayed acrylic sealer on it (just one coat) so that it wouldn’t be tacky on the top where I am putting some often-used supplies.

The drawers I labeled with vellum so that the pattern of the fabric wouldn’t be interrupted.  I just love it.

Click here to see all of my Mod Podge projects!

Here’s the before and after again:

Also, you may have noticed my sewing machine cords back there on the left.  I stuck two 3M Command Strips to the wall and I hang my sewing machine cords on them.  That way, when I’m not using my machine and it’s covered up, the cords aren’t under the table getting in the way.  Genius, right?!  🙂





Add a comment...

Your email is never published or shared. Required fields are marked *